cat6 patch panel management subsystem is the most important component is to achieve vertical lines and two horizontal cabling subsystem cross-connect hub. MDF is usually installed in a cabinet or on the wall, commonly used in network engineering twisted pair patch panels and fiber optic patch panels patch panels.
12 port patch panel
2014年6月20日星期五
cat5e patch panel uses
MDF is positioned in front of the central office of information points modular device management. The front of the information point cat6 patch panel into the equipment room after the first into patch panels, patch panels will hit the line modules, patch panels and switches then connect a jumper (RJ45 interface) . Overall, the patch panel is used to manage the device, for example, if there is no patch, direct access to the front of the information points to the switch, so that once the cable problems, faced to rewiring. In addition, the 48 port patch panel management is also a bit confusing, multiple plug may cause damage to the switch port. MDF exist to solve this problem by replacing the jumper to achieve better management.
订阅:
博文评论 (Atom)
没有评论:
发表评论